JEEP JK SHOCK SKID PLATE REAR FALCON HD KIT FOR 07-18 WRANGLER JK TERAFLEX

Although our JK/JKU Falcon Performance Shock are designed to take a beating with their nearly indestructible hard anodized 6061-T6 aluminum construction, we offer bolt-on JK/JKU Falcon HD Rear Shock Skid Plates to give the serious off-roader extra peace-of-mind when leaving civilization behind. These skid plates are designed specifically for JK/JKU Falcon Series 3 Piggyback Shocks but can also be used with Series 2 Monotube Shocks.

Constructed from 1/4 inch cold rolled steel with the same Eco-Guard mounting hardware found on our Falcon Performance Shocks. Unlike our standard JK/JKU Falcon Bolt-On Rear Shock Skid Plates, we left our HD Rear Shock Skid Plates raw for Jeepers who want to weld them on for more strength (welding recommend, but not required).
Fits:

• JK Wrangler (2 Door)
• JKU Wrangler Unlimited (4 Door)
• 3.4 Remote Air Adjust Piggyback
• 3.3 Fast Adjust Piggyback
• 3.2 Adjustable Piggyback
• 3.1 Piggyback
• 2.1 Monotube Sport
• 2.1 Monotube

Includes:

• Bolt-on HD Rear Shock Skid Plates - pair
• All necessary hardware

Features and Benefits:

• HD Rear Shock Skid Plates:
• Raw finish for those who want to weld the skid plates (not required)
• 3 shock mounting heights possible (stock height; + 0.8 inch; + 1.6 inch)
• Welding not required, but highly recommended for extreme use
• Falcon Rear Shock Skid Plates:
• Designed specifically for rear JK/JKU Falcon Series 3 Piggyback Shocks
• Can also be used w/ rear JK/JKU Falcon Series 2 Monotube Shocks
• Constructed from 1/4 inch cold rolled steel
• Eco-Guard mounting hardware passes 1,000-hour salt spray corrosion test
• 100 percent bolt-on installation w/ basic hand tools - includes all necessary hardware
• TeraFlex Lifetime Warranty

Note(s):

• Requires aftermarket wheels w/ 4.5 inch backspacing or less - or Offset Wheel Adapters for stock wheels (part number 1055000).
• Requires cutting of stock lower shock mount.
• Raw finish for optional welding - welding not required, but highly recommended for extreme use.
• 3 shock mounting heights possible (stock height; + 0.8 inch; + 1.6 inch)
• Mounting at Level 2 or Level 3 may affect overall rear axle travel, causing the axle to droop further, which may cause the spring to fall out of place.
• Install Time: 2 Hours